Corvair Forum

This is the distributor. The miss was there before I put in the new hei distributor the same as it is now


Sent from my iPhone using Corvair Forum mobile app

Has new wires and plugs and a brand new electronic distributor. Yes if you hold it a little above an idle is when you get the sputter.


Sent from my iPhone using Corvair Forum mobile app

Thanks for the info vairguy. I only have single exhaust. May check with a heat gun


Sent from my iPhone using Corvair Forum mobile app

Good morning
I have a 1964 with a miss. Rebuilt carburetors , brand new electronic ignition and each cylinder has 100-120 psi You don’t notice it at idle but when you rev it up you can hear it. Thanks in advance


Sent from my iPhone using Corvair Forum mobile app

Very nice. And good luck with the restoration. Love the early models


Sent from my iPhone using Corvair Forum mobile app

Very nice job


Sent from my iPhone using Corvair Forum mobile app

GOOD EVENING
Good news with a good compression tester compression is good . So I toke the carb apart and blew it all out and set float. It was ok any way.
Now when you put your hand over the carb it makes a difference in the way it idols. the engine pulls down. But I still have a miss under a load ...

The compression tester I was using was junk so I have another and am going to try it this week sometime. No more leakage than I am getting back through the tubes I would say it is normal leakage. I did the pressure test and nothing coming out of the intake or exhaust nothing that you can hear from ...

So I put ATF fluid on top of the cylinder to help find where it was leaking. So when I pressurized the cylinders with 75-100 PSI of compressed air I assume some was leaking by the pistons and turning into mist and coming back out the push rod tubes. A little not

HELLO I was asked to give some back ground . So am 59 years old I live in Missouri. I have been in industrial maintenance my whole adult life. I am currently a maintenance manager for a large factory . I recently purchased a 1964 two door Corvair with 3700 original miles I believe to be true. I got ...

I bought a 1964 with 37000 actual miles I believe to be true. I had a miss issue at any thing more than idle. I pulled plug wires off one at a time and found that all three cylinders on the right when I pulled the wires didn't make much difference to the way it idled. did a compression check and had ...

Hello every one new to Corvair ownership I bought a beautiful 1964 2 door coupe I will be posting some tech questions Thanks for having this Forum