Page 1 of 1
Clarks fender repair parts
Posted: Fri Feb 21, 2014 2:32 pm
by Billyboy12
I ripped my fender open. I have a parts car but it's a nice ca. Monza (no rust) I just hate to start cutting it up. I looked on Clarks to see if they have a metal repair piece I could get from them. I saw that they do sell some front qp tin parts but not the tops of the qt. does anyone know if they do sell the qp piece I need? If so how much will it set me back? I thought of using glass but was told here on the forum that is just a 2nd rate repair. If I was to use glass I could use the Monza as a mold.
Re: Clarks fender repair parts
Posted: Fri Feb 21, 2014 3:18 pm
by 2manyvairs2fix
Billyboy, In my opinion a proper steel section can be installed in less time than it would take to do a glass repair.
If you are not a member of the club nearest you, contact Davemoto here on this site.
He probably has the section you need. And could put you with someone to do the work. Good luck.
Rod
Re: Clarks fender repair parts
Posted: Fri Feb 21, 2014 10:15 pm
by Billyboy12
2manyvairs
Thanks for getting back to me. I went to Motoheads web site and sent him two e-mails. Haven't heard back from him. I'll send him another.
Re: Clarks fender repair parts
Posted: Sat Feb 22, 2014 7:42 am
by bbodie52
Re: Clarks fender repair parts
Posted: Sat Feb 22, 2014 10:59 am
by davemotohead
I have never Received an Email From you? I checked the Guest Book on my site and did not see anything there either,I do have that part in stock,I can cut it from the belt line up to make it easy to ship, my email is attached to my Signature on here,Thanks,Dave
Re: Clarks fender repair parts
Posted: Sat Feb 22, 2014 2:29 pm
by Billyboy12
Thanks Dave I sent you two e-mails now, hope you get them this time
