Happy Saturday!
A 9/16 wrench jumped right out of my hand and into the fan shroud!
Do I need to pull the turbo to remove the shroud and reclaim the wrench?
Thank you
Fan Shroud '64 Spyder
-
- Posts: 1604
- Joined: Tue Mar 25, 2014 9:18 pm
- Location: Kalamazoo Mi..
Re: Fan Shroud '64 Spyder
You should try a magnet first, I have one on a copper wire. Don't know where I bought it though, try looking in the spark plug holes. Also look in the heater box to be sure it didn't make all the way down.
64Powerglide, Jeff Phillips
Kalamazoo, Mi..
Kalamazoo, Mi..
Re: Fan Shroud '64 Spyder
Good idea 64powerglide. Thank you.
- Frank DuVal
- Posts: 574
- Joined: Wed Dec 09, 2009 4:58 pm
Re: Fan Shroud '64 Spyder
I have never seen a wrench make it all the way to the lower shroud. It would have to be a 1/8" is cross section! Maybe 1/4" on an FC engine with no "normal" dip stick tube.
Yes, magnet. Look in all 6 plug holes (well maybe not #5 on the turbo engine) and the oil cooler cover.
Frank DuVal
Yes, magnet. Look in all 6 plug holes (well maybe not #5 on the turbo engine) and the oil cooler cover.
Frank DuVal
Frank DuVal
Fredericksburg, VA
Hey look, blue background!
Fredericksburg, VA
Hey look, blue background!
Re: Fan Shroud '64 Spyder
Thanks Frank. The wrench slid down off the fan on the drivers side. I found a magnet on a wire, will pull the plugs tomorrow.