![thumbsup :tu:](./images/smilies/thumbsup.gif)
Corvair newby
-
- Posts: 6
- Joined: Wed Jun 10, 2015 8:19 pm
- Location: Osceola, iowa
Corvair newby
Hi all. Just bought my wife a 65 Corvair Monza convertible for her 50th birthday. I know next to nothing about these cars but looking forward to learning all I can! The car I picked up has what I am reading on these sites is pretty normal rust for a convertible. The front floors are shot as well as the floor supports. A little minor rust in 1 quarter panel and rockers on both sides need fixed. But other than that the body isn't too bad. So any suggestions on rebuilding floor supports would be very helpful. ![thumbsup :tu:](./images/smilies/thumbsup.gif)
![thumbsup :tu:](./images/smilies/thumbsup.gif)
- flat6_musik
- Posts: 2659
- Joined: Sun Apr 04, 2010 10:03 am
- Location: Hesperia, CA
Re: Corvair newby
Welcome and good luck on your new project!