Negative Camber/Urethane Bushings

All Models and Years
lalkie01
Posts: 33
Joined: Sat Nov 16, 2019 2:02 pm

Re: Negative Camber/Urethane Bushings

Post by lalkie01 »

I don't think the special washers will fit with the bushings I have. As I understand the special washers they have a protrusion that basically fits in the end of the bushing too help support it. I could cut off the sleeves and either buy or make some washers with the protrusion. Or I could purchase rebuilt rods from clarks. I may leave what I have and watch it too see how it works. I appreciate the comments. Do you know the outside diameter of the protrusion on the washers? Larry

joelsplace
Posts: 1035
Joined: Wed Oct 13, 2010 12:51 pm
Location: Northlake, TX

Re: Negative Camber/Urethane Bushings

Post by joelsplace »

If your bolts fit the inside of the sleeves then the sleeves are too small for the special washers. The special washers take up the space between the large sleeve and small bolt. The protrusion on the washer fits inside the sleeve.
114 Corvairs, 5 Ultravans and counting
Northlake, TX

User avatar
terribleted
Posts: 3657
Joined: Sun Apr 18, 2010 2:36 pm
Location: Atlanta, GA
Contact:

Re: Negative Camber/Urethane Bushings

Post by terribleted »

Here is a pic of one of the washers. The center hole is 1/2”, the outside of the raised center is about 9/16”, the overall diameter is 1 1/8” or so
B49C91FB-283C-4F0D-B0B3-DB5239D34102.jpeg
Corvair guy since 1982. I have personally restored at least 20 Vairs, many of them restored ground up.
Currently working full time repairing Corvairs and restoring old cars.
https://www.facebook.com/tedsautorestoration/

Located in Snellville, Georgia

User avatar
thewolfe
Corvair of the Month
Corvair of the Month
Posts: 227
Joined: Thu Feb 27, 2014 4:01 pm
Location: Portland, OR

Re: Negative Camber/Urethane Bushings

Post by thewolfe »

Sounds like you have the wrong bushings. Without showing us exactly what you have we are all speculating. My advice...buy rebuilt rods or get the correct bushings from a corvair vendor. But it sounds to me like whatever you have is not meant to be used with the special washers which is fine as long as the hole in the sleeve is the same as the bolt diameter. Regardless, they shouldn't be that squishy so it really doesn't matter. Do yourself a favor and get the correct parts from a reputable corvair vendor.
Nate Wolfe
65 corsa 180

User avatar
flat6_musik
Posts: 2392
Joined: Sun Apr 04, 2010 10:03 am
Location: Hesperia, CA

Re: Negative Camber/Urethane Bushings

Post by flat6_musik »

I had the same same SAME problem with a 63 nova convertible I had! It had chronic un-adjustable lower control arms. I'd adjust them via the eccentric adjuster, drive it around the block, and then it would be completely out of whack. Drove me insane! I then realized that it was missing those special washers that fit inside the center metal sleeve of the bushing.

Without them, it's just the bolt slopping around inside that sleeve and absolutely a waste of your time. I'm convinced that is why the previous owner sold that nova to me!

Post Reply

Return to “Ask your Mechanical Questions here”