Corvair Forum

On a late model couple do the alignment specs change as the rim diameter chaqnges like to 15 inch and 195/65/15 tires.

thanks

Thanks everyone for the info, I appreciate your input. This looks to be a challenge but worth trying to do it myself.

Rich

looking for video or anyone who has R&R their front bucket seats trim covers - need to replace the ft back on my 66 - I assume hog rings are keepting it in place. Did you find that you needed to replace the foam bun too? How about removal of the 3 the bright metal trim bits - e -z or? I didn't s...

Hi - FOR SALE Late model coupe rear glass; non tinted - $125 - Detroit area

no this is a 1966 110 engine - where is the procedure you explained in the Corvair shop manual i couldn't find it. And what do you mean with the term "bell-crANK" , what's this?

THANKS

ok got it Frank. thanks for the clarification and your help - the horns seems to be working as normal now.

On my 1966 110hp when cold and when I "set" the choke (fast idle cam) the carb'S linkage does not set it up on the high lobe so I can get a higher idle when cold. I can manually do this of course, but by depressing the throttle down it does not set this on the highest cam. What's the fix -...

Frank - what special washer are you referring to I have no washer - just 3 brass screw that attach the part that the horn button snaps to and has a long leg that goes to the horn's plunger inside of the steering wheel hub.

I have a wood sport (GM OE PART) steering wheel on my 66 coupe.

Question - how / what readings are you looking for when checking the horn relay with a multi meter to see if it's bad? Thanks

thanks for your input - RD

the horn in my 1966 Coupe just went off while the car was sitting in the driveway - what could cause this - bad horn relay?
Can you tap the relay to see if it's sticking - and how to trouble this correctly? I have not looked but I believe the horn relay is mounted in the trunk.

thanks

Corvair community - I'm looking for a pair of LM front lower control arm bushings - NOS. No clark's parts please - thanks for reading.

Gentlemen; I just checked my engine and my carb linkage does not go and rest on any of the steps on the cam - I can maually set this by hand of course, but hitting the thottle once with a cold eninge does nothing to set it on the step cam-what could be the issue with the linkage not setting the chok...

thanks Frank I'll check out the Delco manual and clean my linkage - as I said sometimes my car starts and runs on the higher cam - its just not consistent.

thanks everyone for the info- I appreciate the feedback. Brad B. could you mark-up and circle the area on the picture of the carb's linkage the areas where the "tag" is that gets bent to ensure its on the highest "step" when cold......of I ma in the Detroit area too, but this con...

yes; the car was on the aligment rack when begain to tighten the bolts, we noticed the rubber starting to distort and come out of the shell....the Clarks b ushings that failed were only 6 years old and had maybe 2800 miles of use - and the NEW Clarks bushing I just put in are failing as we trird to ...