I have not been able to find the stud that mounts to the carb arm and connects to the cross shaft linkage. I can find it in diagrams on clarks Corvair online store. (page 50 near the bottom) https://ssl.corvair.com/user-cgi/catalo ... ow_page=50 It is the ball stud that goes on the carb side of the linkage swivel. Does anyone have a part number or source for this part? Or is this something I should be able to find at a hardware store?
Trying to get the engine compartment all put together properly then I will move to the interior of the car.
1963 Spyder carb linkage
1963 Spyder carb linkage
1963 Impala SS convertible project
1963 Monza Spyder project
1963 Impala coupe Pro Street Project
1964 Monza Parts car
1963 Impala hard top sedan parts car
1963 Monza Spyder project
1963 Impala coupe Pro Street Project
1964 Monza Parts car
1963 Impala hard top sedan parts car
Re: 1963 Spyder carb linkage
Well I'm going to try this from Jegs.
https://www.jegs.com/i/JEGS/555/15745/10002/-1
I figure if it doesn't fit on the existing head I get the clamp also and if none of this works on my linkage I just need to get a peice of 10-32 all thread and cut it to length and replace the whole rod.
https://www.jegs.com/i/JEGS/555/15745/10002/-1
I figure if it doesn't fit on the existing head I get the clamp also and if none of this works on my linkage I just need to get a peice of 10-32 all thread and cut it to length and replace the whole rod.
1963 Impala SS convertible project
1963 Monza Spyder project
1963 Impala coupe Pro Street Project
1964 Monza Parts car
1963 Impala hard top sedan parts car
1963 Monza Spyder project
1963 Impala coupe Pro Street Project
1964 Monza Parts car
1963 Impala hard top sedan parts car
- Bruins_Fan
- Corvair of the Month
- Posts: 374
- Joined: Wed Aug 08, 2012 9:45 am
- Location: North Shore, MA
Re: 1963 Spyder carb linkage
Have you called Clark's? They're pretty helpful with questions like that.
'66 Monza Convertible 110hp Powerglide