Search found 6 matches
- Tue May 28, 2024 10:49 am
- Forum: Ask your Mechanical Questions here
- Topic: LM front spring revisit
- Replies: 4
- Views: 184
LM front spring revisit
Thinking again about cutting my fronts; I don't care much for the "nose up" stance. If I pull the shock, carefully drop the lower arm, does the brake line need to be disconnected, or is there enough slack, typically? Then, does something need to be done to the cut end of the spring so it s...
- Fri May 17, 2024 5:11 pm
- Forum: Corvair Talk
- Topic: New owner here- couple questions
- Replies: 10
- Views: 1034
Re: New owner here- couple questions
Check the ground at the tank, where the black wire comes off the sending unit and bolts to the frame rail. Take the bolt out, clean the connection and the point on the rail where it bolts to, and reassemble. If that doesn't help, the dash ground may be the culprit. You'll need to pull the dash clust...
- Wed Apr 10, 2024 4:50 pm
- Forum: DIY - Explanations and Demonstrations
- Topic: Late Model Headlight Bezel Stripes
- Replies: 9
- Views: 982
Re: Late Model Headlight Bezel Stripes
just ordered! can't wait!
- Wed Feb 21, 2024 4:52 pm
- Forum: Ask your Mechanical Questions here
- Topic: cylinder 6 acting up
- Replies: 13
- Views: 456
Re: cylinder 6 acting up
Well....... leak down test was done, passed with no problems. The guys took the secondaries off, and they're both soaked, as if dumping fuel. They used 2 block off plates, and the car is back to its old self, running well. They'll go thru the carbs and let me know what's happening.
- Tue Feb 20, 2024 6:48 pm
- Forum: Ask your Mechanical Questions here
- Topic: cylinder 6 acting up
- Replies: 13
- Views: 456
Re: cylinder 6 acting up
We're pulling my engine to swap with a "loaner" to get me back on the road until mine is done...
- Tue Feb 20, 2024 11:45 am
- Forum: Ask your Mechanical Questions here
- Topic: cylinder 6 acting up
- Replies: 13
- Views: 456
cylinder 6 acting up
Hello, 140 PG engine, less than 600 miles. #6 cylinder not having any affect on the engine running. Pull the plug wire, no change, just runs rough. Well, upon further inspection, we've found some things... #6 exhaust push rod is bent, and really dark; also worn where it goes through the guide plate....